Some Tips That You Should Know How to Test The New Installing Print Head for Your Inkjet Printer

  Hi, Nice to see you. When we buy a new print head for our digital printer such as the 5113 or DX-5 print head we may always need to have a test for it. So that we make make sure if the print head has high quality . But do you know how to test the new print head in a right way and what should you pay attention to when you install and test it? Read it and get to know more.

Installing of The Print Head

  Install the nozzle also be careful, must first power off, and put in place. After installed, use hands to push the car and move around, check whether smooth, do not install on electricity, because, if the head is not in place, the car is easy to hit a head and hand feeling, fragmentation, and freely, strong control ability;
  Do not take the ink when you connect the plug and cable, and make sure you have good contact with the socket, do not touch the foot, otherwise it will cause the nozzle to short-circuit and burn;
Attention
  The head of the nozzle is very fragile, absolutely can not bump, be sure to protect. Its surface is a piece of aluminum, the inner layer coated with a crystal oscillator and very small ink tube. A touch will be concave, deformation, and even broken, so that the nozzle on the scrapped.

After Install Your Print Head
 Just installed sprinklers inside there will be air, so it will not immediately print normal, only the head of the air is completely discharged to normal Qi lines; the specific steps are as follows:

  First, the available batch cleaning (only one time for cleaning 2 times, then stop for 30 minutes washing 2 times) repeatedly kept cleaning excessive, will cause the ink cleaning pump, not only make the printing color mixing, ink leakage and waste ink;
  Secondly, you can print more pictures, so that the nozzle in the work out of the air;
  Again, if the machine has caused the waste ink tube to first turn off, then the barrel of a rubber tube out of the waste ink tube until 3-5ML ink, then boot, a normal washing machine, equal to the value of the air is difficult to pull out, side effects It is likely to cause the cleaning pump to piling.




  These all above are my share about how to install your new print head and some tips that you should pay attention to when test it. If you have any needs or questions welcome to contact us at any time. We will provide you with the best quality product and service. Welcome to contact us at any time. Thank you for your reading.




Nanjing Feiyue Digital Technology Co.,ltd
www.heatsub.com
Facebook: Zeo
Whatsapp:+8618752006819
Skype：+8618752006819